After using spray mount to attach the photos to the foam board, I went round using PVA glue to stick down any loose edges.
I then began to contrast the sculpture using nylon wire. The process began by creating holes throughout each layer, and then threading the wire through and creating a knot under each layer to hold it together. I found this the most challenging part of the whole process. Not only did I have to ensure that each hole was in the correct place, and there was enough all around to keep the sculpture from spinning, I also had to make sure the gap between each layer was 1.5cm. I would have ideally liked the gap to be more which would enable the photos to be seen much easier, however the sculpture would look stretched, which has already happened doing it this distance apart.
Interrogating Practice 